Your one-stop shop for all of your Radio needs!
FREE SHIPPING ON MOST ORDERS OVER $100.00 IN THE LOWER 48 STATES.
NO SHIPPING OUT OF THE US OR TERRITORIES.
LARGE ALINCO ORDER IS ON THE WAY, AND YES 330MVT POWER SUPPLIES ARE COMING. CALL ME IF YOU WOULD LIKE TO PRE ORDER. THANKS FOR THE SUPPORT!
The BM-17 is a lightweight single-side or dual-side headset designed for Amateur Radio use. To accommodate different radio setups, the BM-17 is available with either a BM-17-Dynamic element or a BM-17-iC electret element.
The speakers used in the BM-17 are very sensitive and don’t require much AF gain from the transceiver. The frequency response is 200 Hz – 5 kHz with very low distortion. The ear pads are replaceable acoustic foam.
The BM-17-Dynamic headset uses the BM-D dynamic element designed specifically for communications use in Ham Radio. This 600 ohm dynamic element will work on most amateur radio rigs requiring a Low-Z input impedance (usually between 150 ohms and 4k ohms). The BM-17-Dynamic has an operating frequency response of 120Hz – 10 kHz.
The BM-17-iC headset, using our iC electret element, was created for use with Icom radios. This element has been made to utilize bias power in iCOM radios which addresses low-gain issues that arise when using dynamic elements. This element must be paired with the AD-1-iC (included) or AD-1- iCM adapter. The iC adapters have no internal DC blocking capacitor so bias voltage can be passed allowing the iC electret element to operate. The iC element has an operating frequency response of 35Hz – 12kHz.
The microphone audio for the BM-17 series terminates into a 1/8” mono plug while the headphone terminates into a 1/8“ stereo plug (1/8” to 1/4” adapter included).
The boom is designed to be extremely flexible and is swivel mounted to the headphone speaker for optimal positioning in any situation.
The use of the AD-1 series mic adapters allows simple interface with popular transceiver inputs. The adapter cable has a 1/8” female input jack for the headset microphone while the 1/4” female that exits the adapter is the PTT (push to talk) line for the Heil foot switch or hand switch. The 1/8” or 1/4” stereo plug goes into the headphone jack on the transceiver front panel.
Note: To use dynamic mic elements on vintage radios (requiring a high impedance input of 10k to 30k ohms) will require the use of an XT-1 impedance matching transformer.
When I received my call sign a few years back, I was flooded with purchases of junk. Fast forward to 2019. I decided I wanted to build another option, not a dealer who has the same stuff as everyone else, but a dealer who actually uses what he sells. And that’s exactly what I do. If you see a product on this page or one of our tables at Hamfest, you can bet we have tried it and like it. From Radios to connectors we strive to bring you QUALITY. Sure, you can find it cheaper and we understand that, but if you don’t want to buy it again in 6 months, take a look at what we sell and have already approved. I am always just a phone call away. Jim Gifford, KM4MPF.
CALL US AT 1-833-4-KM4MPF AND FIND OUT WHEN WE WILL BE AT A HAMFEST NEAR YOU.
4000 7th ave
Chattanooga, TN. 37407
9:00 till 4:00